Operating Voltage 6V and 12V DC
Reverse Polarity Protection RED LED Indication
Over Voltage Protection RED LED Indication (MAX 30V - 10 seconds)
Battery Types SLA (AGM), GEL & Flooded (WET)
Battery Sizes 6V (1.2Ah – 10Ah) and 12V (1.2Ah to 100Ah)
Ah Capacity Test Simulated 20 hour (C20) load test to 10.50VDC
Ah Calibration Calibrated at 0 (zero) position to brand new fully
charged premium brand SLA batteries rated at
C20hour at 20˚C (68˚F)
Ah Result Based on the battery under test temperature and
state of charge
Ah Adjustment Provides ± Ah adjustment to brand new fully charged
standby SLA, cyclic GEL and car FLOODED lead acid
batteries
Battery Table Recharge or replace battery when Ah capacity
available falls below 65% of the battery’s stated
capacity
Display Type Back-lit LCD
Flat Battery Warning 6V <5.30VDC, 12V <10.50VDC
Repeat Test Operation Can perform repeat tests continuously
DCV Accuracy ± 2% of displayed reading
Ah Accuracy ± 5% Fully charged premium brand C20 hour rated
SLA batteries at 20⁰C - 25⁰C (68⁰F - 77⁰F)
Applied Pulse Load 6A 1.2Ah - 7.9Ah, 18A 8Ah - 100Ah
Ah Cal Adjustment Approx ± 25 dgts
Case Construction High impact ABS with holster
Size (including holster) 84(H) x 170(W) x 41(D)mm
EN 61326-1:2006, Class B (Emissions)
EN 55011:2007, A2 Radiated Emissions Only
EN 61326-1:2006, Basic Requirements (Immunity)
EN 61000-4-2: 1995, A1, A2
EN 61000-4-3: 2006, A1
2004/108/EC (Where Applicable)
NOTE: ACT Meters Ltd reserves the right to
change specication without prior notice.
To Previous Page
Loading...
