Hardware Manual
9
Physical Description
Insert a memory card (not included) into this slot for local
recording purposes. See How to Install / Remove the Memory
Card on page 30 for more information.
NOTE: Supports microSDHC and microSDXC cards.
Use the Reset Button to reset the camera to its factory default
settings. To do the reset, press and hold the Reset button for at
least 5 seconds or until the Power LED lights up. When the
Power LED lights up again, reset is complete. See How to Reset
the Camera on page 33.
The Power LED lights up when the camera is connected to the
power source and goes off once the camera boot-up process is
complete.
NOTE: For typical use, the power LED is hidden inside the
housing and cannot be seen. However, knowing how the power
LED works is essential when troubleshooting or doing a reset.
Connects to a network using a standard Ethernet cable.
Connects to audio input devices, such as a microphone with
built-in amplifier, etc.
NOTE: The microphone must have a built-in amplifier.
Connecting an ordinary microphone will dwarf sounds and will
result in inaudible recording.
Connects to audio output devices, such as a speaker, etc.
To Next Page
Loading...
