1. Click Quality of Service at the top of the Home screen, then click DSCP
Settings. The “DSCP Settings” screen appears.
2. To edit an existing entry, click the appropriate icon in the “Action” column. To add
a new entry, click Add. In either case, the “Edit DSCP Settings” screen appears.
3. Configure the following parameters:
DSCP Value (hex) - Enter the DSCP value as a hexadecimal value.
802.1p Priority - Select a 802.1p priority level from the drop-down list, zero
being the lowest and seven the highest (each priority level is mapped to low/
medium/high priority). The default DSCP value for packets with an unassigned
value is zero.
4. Click OK to save the settings.
To Next Page
Loading...
