ActionTec MI424-WR - Computer Network Configuration; Configuring a Computer to Use Dynamic IP Addressing

14
Actiontec Wireless Broadband Router User Manual
15
Chapter 2 Connecting the Router
3. Connect one end of the coaxial cable to the coaxial wall jack, and the other
end to the red Coax port on the back of the Router.
4. Power up the set top box.
5. Make sure the Coax LAN light on the front of the Router glows steadily
green. This may take a few minutes. When it does, the set top box is con-
nected to the Router.
Computer Network Conguration
Each network interface on the computer should either be configured with a stati-
cally defined IP address and DNS address, or instructed to automatically obtain an
IP address using the Network DHCP server. The Router is set up, by default, with
an active DHCP server, and Actiontec recommends leaving this setting as is.
Configuring a Computer to Use Dynamic IP Addressing
To configure a computer to use dynamic IP addressing:
Windows XP
1. Select Network Connections in the Control Panel.
2. Right-click Ethernet Local Area Connection, then click Properties.
3. In the “General” tab, select Internet Protocol (TCP/IP), then click
Properties.
4. The “Internet Protocol (TCP/IP) Properties” window appears.
5. Click the “Obtain an IP address automatically” radio button.
6. Click the “Obtain DNS server address automatically” radio button.
7. Click OK to save the settings.