quick start guide
ScreenBeam
™
|
960
PN: 0530-0796-004
© 2018 All rights reserved. Actiontec and the Actiontec logo are registered trademarks, and
ScreenBeam is a trademark of Actiontec Electronics, Inc. All other names are properties of
their respective owners. Specifications subject to change without notice.
112618
G. Deploying ScreenBeam Receiver
Please read the deployment guide for best practices and tips
before placing the ScreenBeam 960 to the site for users.
1.
Unplug the power supply and HDMI cable from
ScreenBeam 960 receiver.
2.
Move the receiver to its permanent location.
Note: Access to a wired or wireless LAN connection is
required.
3.
Plug the HDMI cable to the receiver and the display.
4.
Plug in the receiver’s power supply.
5.
Switch the display to the correct input and verify the Ready
to Connect screen appears.
6.
Verify the ScreenBeam 960 obtains a valid IP address.
Support Information
For FAQs, troubleshooting tips and support, visit:
https://support.screenbeam.com
To open a ticket for support, visit:
https://support.screenbeam.com/ticket
Website: www.screenbeam.com
This product is intended to be supplied by a Listed Direct
Plug-In Power Unit marked “Class 2”, Listed Power Adapter
or DC power source marked “L.P.S.” (or “Limited Power
Source”) and rated 5Vdc, 2A minimum.
To Previous Page
Loading...
