When the machine is in continuous operation, the desired humidity set point is still remembered
but is deactivated. The machine will continuously dehumidify, no matter what the humidity set
point is, until it is manually powered off or timed off.
1. Press the CONTINUOUS OPERATION button to enter the continuous operation mode. The
screen will show “Continuous.”
2. Press the CONTINUOUS OPERATION button again to deactivate continuous operation. The
machine goes back to the mode of operating according to the humidity set point.
When there is a frost buildup, the machine will be forced to stop dehumidifying and start defrosting
automatically. The screen shows the machine in “Defrost” process under “Continuous” mode. After
the defrost function ends, “Defrost” disappears from the screen while “Continuous” still shows.
Automatic Restart
In the event of a power failure, the machine will remember what the humidity set point was and
whether the unit was in operating mode before the power failure.
When power is restored, if the unit was operating before the power failure, it automatically restarts
to operate according to the humidity set point in the non-timed mode.
Note that the unit was powered off when a power failure occurs, the unit will remain powered off
until it is turned back on.
The Automatic Restart feature allows the unit to be used with controllers and timers.
On/Off Delay
If the system is turned off after running and you wish to turn it on again, there is a 3-minute delay
before restart as protection to the working components of the unit.
Run
9
To Next Page
Loading...