machine operates by the default current time, the Timing On and Timing Off function,
if set, will
operate according to the default current me, but not the real current me. We strongly
recommend that you set the current me.
3. To set for timed operation, press TIMER/MODE a third time and “Timing on” will display. Use the
“+” button to change hour and the “–” button to change minutes. The timer is in 24-hour format.
4. After you press TIMER/MODE a fourth time, “Timing off” will display. Use the “+” button to
change hour and the “–” button to change minutes.
TIP: You can choose to skip the Timing on and Timing off setting by pressing the TIMER/MODE but
-
ton to exit. If so, you must manually power the machine on or off each time by pressing the POWER
button.
5. Press TIMER/MODE a fifth time to exit the setting mode.
OPERATIONS
Non-timed dehumidifying operation to the desired humidity level
When the timer is not set, the unit dehumidifies up to the humidity set point and automatically goes
to the standby mode when the set point is achieved. After the ambient humidity increases more
than 3%, the dehumidifying function operates again. The machine will continue working in this
pattern until it is manually powered off.
Due to the 3-minute on/off delay design to protect the working components (see On/Off Delay, page
9), the humidity reading may go up more than 3% while the machine remains in the standby mode
since it is within the 3-minute delay protection period. This usually happens under conditions where
the ambient humidity is high. It is not a machine malfunction.
Timed dehumidifying operation to the desired humidity level
When the timer is set, the machine will operate according to the humidity set point (see page 7,
step 2), only after the Timing On time and before the Timing Off time. Before the Timing On time
and after the Timing Off time, the machine is in standby mode. Unless the power supply cord is
unplugged, the machine remembers all set points in the standby mode and will automatically
operate according to the timer setup every day.
You can manually override the timer function to start or stop the dehumidifying function by
pressing the POWER button. The machine resumes to the timer mode in the next 24-hour cycle.
Automatic Defrost
The unit will automatically go into defrost mode when frost forms on the evaporator coil. The screen
shows “Defrost.” After 15 minutes of defrost time the unit will resume operation. When in the defrost
mode, the unit does not dehumidify.
Continuous dehumidifying operation
NOTE: Use this setting when operating this dehumidifier with a timed humidity controller.
Run
Set
Run
Set
Run
8
To Next Page
Loading...