13
Carry out the following checks: Daily Weekly Monthly Annually
Full function test of the equipment.
Check the water temperatures from the mixer
Check the waste system for damage and leakage.
Examine the supply hoses for damage and leakage
Service internal mixer components.
(may require more frequent servicing in hard water
areas)
Calibrate mixer temperatures
Check cold supply failure shutdown
Check condition of backup battery
Check The security of the floor fixings
Load test the seat & bath (every 6 months to comply
with LOLER regulations)
Cleaning your Bath
• The bath may be cleaned using most mild cleaning agents.
• Chemical agents, bleach and solvents must NOT be used, i.e. drain cleaners,
acetone, sodium hypochlorite, oven cleaners or acids.
• The taps, side and end panels and handset should be cleaned using a warm
soapy solution and rinsed with a damp cloth.
• The seat base and back may be detached for cleaning.
• Attention should always be paid to instruction labels for the cleaning agent.
Troubleshooting
• In the event of a mains electricity power failure, the system has a back up
battery system which will allow you to transfer the client out of the bath. Further
use will be disabled until the power is restored.
• If the bath will not move and emits a constant tone then check the mains
power is connected and the supply is O.K.
MAINTENANCE &
TROUBLE SHOOTING
To Next Page
Loading...