4.4 USER DEFINED PROGRAM
There are three program U1, U2, U3 for user defined.
Press “PROGRAM” continuously under standby mode until window display U1-U3,press “MODE” to start
setting first segment, setup speed and incline by pressing ‘SPEED + -’ 、 ’ SPEED （ 3 6 9
12）’、’’INCLINE + -’’、’’NCLINE（3 6 9 12）’’, .press “MODE” finish first segment setting and enter
second one, until finish all 20 segments. The data will be permanently saved until user reset next time.
The U1 is usually with default speed 1KM/H, incline 0. The U2 is usually with default speed 2KM/H,
incline 0. The U3 is usually with default speed 3KM/H, incline 0.
At the end of the program mode the treadmill will flash with 15 beeps, after which all data
will be cleared to 0 and come into standby status.
5. HEART BEAT TEST
When holding the hand pulse by two hands, the pulse window will show your heart beat after 5 seconds.
In order to get an accurate heartbeat value, please holding the hand pulse more than 30 seconds to test
when the machine stop. The heart beat data is just for reference, can not be as the medical data.
6. BODY FAT TEST
When the treadmill standby, press ‘ PROGRAM’ button till ‘ FAT’ show in the window. ‘FAT’ is body fat
test mode. Press ‘ MODE’ to choose parameter ‘ SEX / AGE / HEIGHT / WEIGHT’, Corresponding
window will show “-1-”
，
“-2-”
、
“-3-”“-4-". When set each parameter, press SPEED+/-(INCLINE+/-) to
adjust the data, and Corresponding window will show the data and press ‘MODE’ button to finish, the
window will show“-5-” and“---” enter into ready to go condition. Hold the handle pulse with two hands, it
will show your BMI data after 5 seconds.
6.1 Data display and set range
Parameter
Type
default Setting range mark
SEX（-1-） 0（MALE） 0—1 0= MALE 1= FEMALE
AGE（-2-） 25 10—99
HEIGHT（-3-） 170 CM 100—240 CM
WEIGHT（-4-） 70KG 20—160KG
To Next Page
Loading...