sides ,if the best not too tight nor loose.
CENTER THE RUNNING BELT
●Place treadmill on a level surface. Run
Treadmill at approximately 6-8KM/H, checking
the running condition.
If the belt has drifted to the right, pull out of the
save clock and switch, turn the right adjusting
bolt 1/4 turn clockwise, then start running until
centering the belt. PIC A
If the belt has drifted to the left ,pull out of the
safety clock and switch, turn the left adjusting
bolt 1/4 turn clockwise ,then start running until
centering the belt .PIC B
Timely adjust the tightness of the belt ,for the
looseness after a period of time running. Pull
out of the safety clock and switch , turn the left
and right adjusting bolt 1/4 turn clockwise ,then
re-start running, confirm the belt-tightness until
the belt be right tightness. PIC C
To Next Page
Loading...
