Active Products XE03 - Troubleshooting; Motor Will Not Start Troubleshooting; Low Pressure Troubleshooting; Variable Pressure Troubleshooting

16
TROUBLESHOOTING
Disconnect the machine from the power source before making any repairs.
4ZNQUPNCause 4PMVUJPO
Motor will not start. On/Off switch is in the
i0''w0QPTJUJPO
5VSOTXJUDIUPUIFi0/w
( | ) position.
Power cord is not plugged in. Plug in power cord.
Extension cord is too long.
Extension cord is not
proper gauge.
Extension cord is damaged.
Replace extension cord
with either a 25’ (7.6 m)
14AWG cord or a 50’ (15 m)
14AWG cord.
Electrical outlet does not
supply adequate power.
Try a different outlet.
Tripped pressure washer
circuit breaker
"MMPXUPDPPMBOESFTUBSUVOJU
Unit does not reach
high pressure.
Diameter of garden hose is
too small.
3FQMBDFXJUIBwNNPS
wNNHBSEFOIPTF
Water supply is restricted. Check garden hose for
LJOLTMFBLTBOECMPDLBHF
Not enough water supply. Open water source fully.
Water inlet filter is clogged. Remove filter and rinse in
warm water.
Power nozzle is in low-
pressure position.
Turn power nozzle to high-
pressure position.
Pump is sucking air. Check that hoses and
fittings are airtight. Turn
i0''wNBDIJOFBOEQVSHF
pump by squeezing trigger
HVOVOUJMBTUFBEZnPXPG
water emerges through
the nozzle.
Output pressure varies high
and low.
Not enough inlet water supply. Turn water on fully. Check
HBSEFOIPTFGPSLJOLTMFBLT
or blockage.
Pump is sucking air. Check that hoses and
fittings are airtight. Turn
i0''wNBDIJOFBOEQVSHF
pump by squeezing trigger
HVOVOUJMBTUFBEZnPXPG
water emerges through
the nozzle.
Water inlet filter is clogged. Remove filter and rinse
with warm water.