ActiveProducts XE06 - Operational Procedures; Operating Procedures

9 10
ON
OFF
ASSEMBLY AND OPERATING INSTRUCTIONS
9
10
13
Attach garden hose to water supply and
turn water on.
Make sure the ON/OFF switch is on the
OFF position.
Completely unwind power cord and plug the
unit into an outlet.
ASSEMBLY AND OPERATING INSTRUCTIONS
Press the ON Button.
CAUTION
Drain unit after each use (for
storage): remove water
connection, turn ON the
machine for a few seconds
and press gun trigger to bleed
remaining water in the pump.
Turn OFF immediately.
11 12
Depress trigger until there is a steady
stream of water.
AdjustableSprayNozzle
The adjustable spray nozzle can be adjusted from fan to jet. The spray is adjusted from jet
to fan spray by turning the nozzle.
Working with detergent ensures a quick soaking of the dirt, and allows the high-pressure
water to penetrate and remove the dirt more effectively. Always spray detergent on a dry
surface, do not pre-soak area. Wetting the surface rst dilutes the detergent and reduces
its cleaning ability.
To apply detergents you must be operating at low-pressure. This provides a gentle applica-
tion of detergent, with the pressure equivalent to a lowest garden hose. The high-pressure
setting is used for cleaning; you cannot apply detergents when working at high-pressure.
Always test detergent in an inconspicuous area before use.
CAUTION
Onlyusecleaningdetergentsrecommendedforpressurewashers.
USING THE ACCESSORIES
WORKING WITH DETERGENTS
Engage gun safety lock.
Set the adjustable wand to the low-
pressure setting by pulling the nozzle out.
The wand must be set in the low-pressure
position to apply detergent.
CAUTION
Jetsprayadjustmentisveryaggressive.Donotadjustwhilespraying.
1 2