ActiveProducts XE06 - Shutting down and Cleaning up; Taking a Break

11 12
ASSEMBLY AND OPERATING INSTRUCTIONS
4
Turn on the pressure washer. Pull trigger to operate unit. The liquid detergent will automati-
cally mix with water, and be discharged through the nozzle at low pressure. Apply detergent
to a DRY work surface, from bottom to top.
Gently pull detergent container out of storage position, and ll
with detergent. Push containers back into storage position.
5
6
7
Allow detergent to remain on the surface for a short time before rinsing. Do not allow
detergent to dry on surface.
Rinse with clean water under high pressure. On a vertical surface, rinse from the
bottom up, then rinse from the top down to avoid streaking. Hold nozzle 6-8” (15-20
cm) from the work surface, at a 45° angle.
When you have nished using the detergent injection system, ll detergent bottle
with clean water. Siphon water at low pressure for one minute, so that all detergent is
ushed through system. Remove detergent bottle, and rinse it thoroughly.
CAUTION
Damagemayoccurtopaintedsurfaceifchemicalisallowedtodryonsurface.Wash
andrinseasmallsectionatatime.Avoidworkingonhotsurfacesorindirectsunlight.
3
CAUTION
Failuretocleanproperlywillcausethedetergentinjectionsystemtobecome
cloggedandinoperable.
CAUTION
Neveruse:
•Bleach,chlorineproductsandothercorrosivechemicals
•Liquidscontainingsolvents(i.e.,paintthinners,gasoline,oils)
•Tri-sodiumphosphateproducts
•Ammoniaproducts
•Acid-basedproducts
Thesechemicalswillharmtheunitandwilldamagethesurfacebeingcleaned.
TAKING A BREAK
1
3
2
Engage gun safety lock.
Unplug the power cord from the outlet.
Turn unit to “OFF” (O) position.
If taking a break of five minutes or more:
SHUTTING DOWN AND CLEANING UP
1
3
2
4
(If you are not using detergent, go directly to Step 2.) When you have nished using
the detergent injection system, ll detergent bottle with clean water. Siphon water at
low-pressure for one minute so that all detergent is ushed through system. Remove
detergent bottle and rinse it thoroughly.
Unplug the power cord from the outlet.
Turn off the water supply.
Turn the switch to “OFF” (0) position.
Press trigger to release any remaining water pressure.
5
6
7
Disconnect the garden hose from the water inlet on the unit.
WARNING
Turnoffwatersupplyandsqueezetriggertodepressurizetheunit.Failuretodoso
couldresultinpersonalinjuryduetodischargeofhigh-pressurewater.
Engage gun safety lock.
ASSEMBLY AND OPERATING INSTRUCTIONS