Actron OBD II PocketScan Code Reader CP9125 User Manual

NOTE: If diagnostic trouble codes (DTCs) are already being
displayed from a previous read operation, press and hold
READ/ScrREAD/Scr
READ/ScrREAD/Scr
READ/Scr
oll Dooll Do
oll Dooll Do
oll Do
wnwn
wnwn
wn key for 3 seconds and release.
6.Observe a Moving
*
on Display.
NOTE: If a “
No LinkNo Link
No LinkNo Link
No Link” message
displays, cycle ignition key to
the OFF position for 10
seconds, then back ON and repeat “Reading Diagnostic
Data.”
7. View Codes on Display
NOTE: If there are no codes present,
the tool will display “
00
00
0
CodesCodes
CodesCodes
Codes” and proceed to
display MIL Status when
READ/ScrREAD/Scr
READ/ScrREAD/Scr
READ/Scr
oll Dooll Do
oll Dooll Do
oll Do
wnwn
wnwn
wn is
pressed.
• To View Codes press and
release
READ/ScrREAD/Scr
READ/ScrREAD/Scr
READ/Scr
olloll
olloll
oll
DoDo
DoDo
Do
wn wn
wn wn
wn key.
• If the code is a Pending
Code a Vwill be displayed.
*
No Link
P0443
P0452
V
0 Codes
3 Codes




8

Actron OBD II PocketScan Code Reader CP9125 Specifications

General

Power Source	Vehicle's OBD II port
Compatibility	OBD II compliant vehicles
Display	LCD
Connectivity	OBD II
Features	Reads and erases diagnostic trouble codes (DTCs)
Functions	Diagnostic trouble code (DTC) reading and clearing
Supported Protocols	J1850 PWM, J1850 VPW, ISO9141-2, ISO14230-4 (KWP2000), ISO15765-4 (CAN)