Actron OBD II PocketScan Code Reader CP9125 User Manual

Erasing Diagnostic Trouble Codes and Data
Erasing allows the PocketScan
TM
Code Reader to delete the codes
and I/M Monitor status from the vehicle’s computer modules.
Only Erase Diagnostic Data after checking
system completely and writing down results.
Avoid Cooling Fan! Fan may turn on
during test.
1.Turn Ignition Key to the Off Position.
2. Locate and Plug in Data Link
Connector (DLC.)
NOTE: The data link connector
should be located under
the dashboard on the
driverside of the vehicle.
If the data link connector is not located under the
dashboard as stated, a label describing the location of
the data link connector should be there.
3. Observe Display toggles between
“Pocket” and “Scan”.
4.Turn Ignition Key to the ON Position
leaving Engine Off.
NOTE: Make sure that the Ignition Key is
ON and NOT in the Accessory
Position.
IMPORTANT
!
WARNING
O
F
F
O
N
O
F
F
O
N
Scan
10

Actron OBD II PocketScan Code Reader CP9125 Specifications

General

Power Source	Vehicle's OBD II port
Compatibility	OBD II compliant vehicles
Display	LCD
Connectivity	OBD II
Features	Reads and erases diagnostic trouble codes (DTCs)
Functions	Diagnostic trouble code (DTC) reading and clearing
Supported Protocols	J1850 PWM, J1850 VPW, ISO9141-2, ISO14230-4 (KWP2000), ISO15765-4 (CAN)