12
Problem Possible Solution
• Navigate to “192.168.4.1” in your web browser.
Conrm that your Station ID and Station Key are
entered correctly.
Inaccurate
temperature or
humidity
• Make sure both the display and 3-in-1 sensor are
placed away from any heat sources or vents (see
page 9).
• Make sure both units are positioned away from
moisture sources (see page 9).
• Make sure 3-in-1 sensor is mounted at least 5 ft off of
the ground.
Inaccurate wind
readings
• What is wind reading being compared to? Pro
weather stations are typically mounted at 30 ft high
or more. Make sure to compare data using a sensor
positioned at the same mounting height.
• Check location of the sensor. Ensure it’s mounted a
minimum of 3 ft in the air with no obstructions around
it (within several feet).
• Ensure wind cups are spinning freely. If they hesitate or stop
try lubricating with graphite powder or spray lubricant.
Troubleshooting
• Your internet router and display must be within range
of each other. Relocate your display closer to your router.
• Ensure the network name (SSID) and password you've
entered are correct. NOTE: Both network name and
password are case sensitive.
• Reset the display by pressing and holding the
RESET button for 10 seconds, located in the battery
compartment of the display. Date and time will need
to be entered after a reset.
• Make sure DCHP is enabled on your router. Most
routers have DHCP enabled by default.
• Ensure your router is broadcasting a 2.4 GHz
network. The weather station display is equipped with
a Wi-Fi module that only supports 2.4 GHz wireless
networks.
Display not connecting
to Wi-Fi
Data not uploading to
Weather Underground
TM
If your AcuRite product does not operate properly after trying
the troubleshooting steps, visit www.AcuRite.com or email
support@chaney-inst.com for assistance.
To Next Page
Loading...
