Additional Features - Auto-Arm Timer
55 seconds after turning off the ignition the alarm will arm automatically
5
TToo ccoonnffiigguurree tthhiiss ffeeaattuurree::
EENNTTEERR CCOONNFFIIGGUURRAATTIIOONN MMOODDEE::
1. Ensure the ingition is switched off.
2. The following 3 actions (a, b and c) must be completed within 10
seconds:
a. Arm and disarm the alarm.
b. Switch the ignition on 5 times and leave it on (on-off-on-off
on-off-on-off-on and leave it on)
c. Hold down all three buttons on the fob until the unit emits a
rapid, low pitch bip-bip-bip-bip.
3. Press the ‘Silent’ button (or torch button on the flip-fob)
oonnccee
to
access auto-arm timer configuration (
or four times to exit the
configuration mode
).
Each time you press the button you will get a high-pitched bip-bip-bip-
bip as confirmation, except the exit mode which is low pitch.
Once this option has been selected, changing it is accomplished as
follows:
1. To switch ON the auto-arm, press the Lock button (key button on
flip fob) and unit emits a high pitched bip-bip.
2. To turn the action OFF, press the Unlock button (P button on flip
fob) and the unit emits a low pitch bip-bip.
It doesn’t matter if you don’t know the current state of the alarm,
just press the button you want it to be. You can press it again, it
won’t cause a problem.
3. When you have the alarm set as you want, press the Silent button
(Torch button on flip-fob) and a low pitch bip-bip-bip-bip will
confirm the programming has ended.
IIff tthhee uunniitt iiss lleefftt iinn uusseerr ccoonnffiigguurraattiioonn mmooddee ffoorr mmoorree tthhaann 11 mmiinnuuttee 3300 sseeccoonnddss,, iitt wwiillll eexxiitt aauuttoommaattiiccaallllyy aanndd ccoonnffiirrmm
To Next Page
Loading...