Acumen CAT3.1 - Page 7

Additional Features - Nudge Sensor Sensitivity
To increase or decrease sensitivity of the nudge sensor
6
TToo ccoonnffiigguurree tthhiiss ffeeaattuurree::
EENNTTEERR CCOONNFFIIGGUURRAATTIIOONN MMOODDEE::
1. Ensure the ingition is switched off.
2. The following 3 actions (a, b and c) must be completed within 10
seconds:
a. Arm and disarm the alarm.
b. Switch the ignition on 5 times and leave it on (on-off-on-off
on-off-on-off-on and leave it on)
c. Hold down all three buttons on the fob until the unit emits a
rapid, low pitch bip-bip-bip-bip.
3. Press the ‘Silent’ button (or torch button on the flip-fob)
ttwwiiccee
to
access nudge sensor sensitivity configuration (
or four times to exit
the configuration mode
).
Each time you press the button you will get a high-pitched bip-bip-bip-
bip as confirmation, except the exit mode which is low pitch.
NOTE! Tilt sensitivity is not affected by nudge sensitivity
Once this option has been selected, changing it is accomplished as
follows:
1. To INCREASE the sensitivity, press the Lock button (Key button on
flip fob). Each press of the fob will raise the sensitivity one ‘notch’
and is confirmed by a high pitch bip-bip.
After each press the motorcycle may be ‘nudged’ to gauge the
sensitivity – if the nudge is detected it will emit a single standard
beep. When the unit reaches it’s maximum sensitivity it will emit
one high pitch bip, instead of two. This will indicate subsequent
presses IN THAT DIRECTION will not make the unit any more
sensitive.
2. To decrease the sensitivity, press the Unlock (P button on flip fob)
Each press will give a low pitch bip-bip.
After each press the motorcycle may be ‘nudged’ to gauge the
sensitivity – if the nudge is detected it will emit a single standard
beep. When the unit reaches it’s minimum sensitivity it will emit
one low pitch bip, instead of two. This will indicate subsequent
presses IN THAT DIRECTION will not make the unit any less
sensitive.
3. When the nudge sensitivity is set as required, press the Silent
button (Torch on flip-fob) to exit configuration mode. A low pitch
bip-bip-bip-bip will confirm.
IIff tthhee uunniitt iiss lleefftt iinn uusseerr ccoonnffiigguurraattiioonn mmooddee ffoorr mmoorree tthhaann 11 mmiinnuuttee 3300 sseeccoonnddss,, iitt wwiillll eexxiitt aauuttoommaattiiccaallllyy aanndd ccoonnffiirrmm iitt hhaass ddoonnee ssoo wwiitthh aa llooww ppiittcchh
bbiipp--bbiipp--bbiipp--bbiipp.. SSwwiittcchhiinngg tthhee mmoottoorrccyyccllee iiggnniittiioonn ooffff aatt aannyy ttiimmee dduurriinngg tthhee pprroocceesssseess aabboovvee ccaauusseess tthhee uunniitt ttoo eexxiitt ccoonnffiigguurraattiioonn wwiitthh aannyy nneeww
ccoommpplleetteedd sseettttiinnggss ssttoorreedd.. TThhee uunniitt wwiillll eemmiitt aa llooww ppiittcchh bbiipp--bbiipp--bbiipp--bbiipp ttoo ccoonnffiirrmm..