Additional Features - Nudge Alarm Reaction
To enable repeated nudging to sound the alarm
7
TToo ccoonnffiigguurree tthhiiss ffeeaattuurree::
EENNTTEERR CCOONNFFIIGGUURRAATTIIOONN MMOODDEE::
1. Ensure the ingition is switched off.
2. The following 3 actions (a, b and c) must be completed within 10
seconds:
a. Arm and disarm the alarm.
b. Switch the ignition on 5 times and leave it on (on-off-on-off
on-off-on-off-on and leave it on)
c. Hold down all three buttons on the fob until the unit emits a
rapid, low pitch bip-bip-bip-bip.
3. Press the ‘Silent’ button (or torch button on the flip-fob)
tthhrreeee
times
to access nudge alarm reaction configuration (
or four times to exit
the configuration mode
).
Each time you press the button you will get a high-pitched bip-bip-bip-
bip as confirmation, except the exit mode which is low pitch.
Once this option has been selected, changing it is accomplished as
follows:
1. To enable repeated nudging to sound the alarm, press the Lock
button (Key on flip-fob). The unit emits a high pitch bip-bip.
2. To disable, press the Unlock button (P on flip-fob) and unit emits a
low pitch bip-bip.
It doesn’t matter if you don’t know the current state of the alarm,
just press the button you want it to be. You can press it again, it
won’t cause a problem.
3. When the nudge alarm reaction is set as required, press the Silent
button (Torch on flip-fob) to exit configuration mode. A low pitch
bip-bip-bip-bip will confirm.
IIff tthhee uunniitt iiss lleefftt iinn uusseerr ccoonnffiigguurraattiioonn mmooddee ffoorr mmoorree tthhaann 11 mmiinnuuttee 3300 sseeccoonnddss,, iitt wwiillll eexxiitt aauuttoommaattiiccaallllyy aanndd ccoonnffiirrmm
To Next Page
Loading...