− If you just took
delivery of your vehicle and have not
trained any of the buttons in the
HomeLink transmitter before, you
should erase any previously learned
codes before training the first button.
Todothis,pressandholdthetwo
outside buttons on the HomeLink
transmitter for about 20 seconds,
until the red light flashes. Release
the buttons, then proceed to Step 1.
If you are training the second or
third buttons, go directly to Step 1.
Unplug the garage door opener
motor from the house current.
Holdtheendofthegaragedoor
opener remote control 2 to 5
inches from the HomeLink
transmitter. Make sure you are
not blocking your view of the red
light in the transmitter.
Before you can use the HomeLink
Universal Transmitter to operate
devices around your home, it must
‘‘learn’’ the proper codes. For
example, to train the transmitter to
open and close the garage door:
Press the button on the remote
control and the button on the
transmitter at the same time. Hold
down both buttons.
Select the transmitter button you
want to train.
2.
3.
4.
1.
Training the Transmitter
Before you begin
HomeLink Universal Transmitter
Instruments and Controls
92
00/08/07 22:01:52 31S3V600_097
To Next Page
Loading...
