Adjust the seat to a comfortable
position (see page ).
Store a driving position only when
the vehicle is parked.
Turn the ignition switch to the ON
(II) position. You cannot add a
new driving position to the
memory unless the ignition switch
is in the ON (II) position. You can
recall a memorized position with
the ignition switch in any position.
Your vehicle has a memory feature
for the driver’s seat and outside
mirror positions.
Adjust the outside mirrors for best
visibility (see page ).
Press and release the SET button
on the control panel. You will hear
a beep. Immediately press and
hold one of the memory buttons (1
or 2) until you hear two beeps.
The indicator in the memory
button will come on. The current
positions of the driver’s seat and
outside mirrors are now stored.
Seat, except for power lumbar, and
outside mirror positions, can be
stored in separate memories. You
select a memorized position by
pushing the appropriate button or
using the appropriate remote
transmitter (Memory 1 or
Memory 2).
3.
1.
2.
131
144
Storing a Driving Position in
Memory
Driving Position Memory System
146
MEMORY BUTTONS
SET BUTTON
０７／０６／０１ １８：４９：４３ ３１ＳＴＫ６１０ ０１５１
To Next Page
Loading...
Need help?
General
