Holding the grip, pull the support
rod out of its clip. Insert the end
into the designated hole in the
hood.
To close the hood, lift it up slightly to
remove the support rod from the
hole. Put the support rod back into
its holding clip. Lower the hood to
about a foot (30 cm) above the
fender, then let it drop. Make sure it
is securely latched.
Wait a few minutes after turning the
engine off before you check the oil.
Park the vehicle on a level surface.
Hold the dipstick with a clean
cloth or paper towel, and then
insert it all the way back in its hole.
Wipe off the dipstick with a clean
cloth or paper towel.
Remove the dipstick (orange loop).
3.
3.
1.
2.
Service Station Procedures
Oil Check
276
GRIP
CLIPSUPPORT ROD
DIPSTICK
０７／０６／０１ １９：０７：１４ ３１ＳＴＫ６１０ ０２８１
To Next Page
Loading...
Need help?
General
