If you want to retrain a programmed
button for a new device, you do not
have to erase all button memory.
You can replace the existing memory
code using this procedure:
Press and hold the HomeLink
button to be trained until the
HomeLink indicator begins to
flash slowly.
If a rolling code transmitter was
previously programmed, the
indicator will flash rapidly for 2
seconds, and then stay on for
about 23 seconds.
If a standard transmitter was
programmed, the indicator will
stay on for about 25 seconds.
Once the HomeLink indicator
begins to flash slowly, continue to
hold the HomeLink button, and
follow steps 2 thru 5 under
‘‘Training HomeLink’’ (see page
).
Toerasethecodesstoredinallthree
buttons, press and hold the two
outside buttons until the red
indicator begins to flash, then
release the buttons.
Youshoulderaseallthreecodes
before selling the vehicle.
Press and hold the button on
HomeLink for 3 to 4 seconds.
Press the HomeLink button again
for about 1 second. It should
operate the garage door.
1.
2.
4.
5.
248
HomeLink Universal Transceiver
Retraining a ButtonErasing Codes
250
０７／０６／０１ １９：０３：４３ ３１ＳＴＫ６１０ ０２５５
To Next Page
Loading...
