In freezing or sub-freezing conditions, the electronic gear selector response
may be slow. Always apply the brake pedal before shifting into Park (P),
and confirm that (P) is shown on the gear position indicator before
releasing the brake.
The vehicle can roll away if left unattended without confirming that Park
(P) is engaged. Always keep your foot on the brake pedal until you have
confirmed that (P) is shown on the gear position indicator.
When you change from D to R and vice versa, or want to change to Park
(P), come to a complete stop and keep the brake pedal applied. Operating
the gear buttons before the vehicle has come to a complete standstill can
damage the transmission.
Auto park mode
For your convenience, Park (P) is automatically engaged when the vehicle
is turned off, or when all of the following conditions are met: the vehicle is
stopped with the engine running, the driver’s seat belt is unbuckled, and
the driver’s door is opened. You should always apply the brake and shift to
Park when idling, or before exiting the vehicle.
If you select any gear other than Park when the driver’s door is opened and
the driver’s seat belt is unbuckled, Park is re-engaged when the brake pedal
is released.
Car wash mode
Follow the procedure below to use a conveyor-style car wash where you or
an attendant do not remain in the vehicle. Make sure the wiper lever is in
the OFF position. You should inform the car wash attendant of this
procedure.
1. When the engine is running, apply the brake pedal, select Neutral (N),
then release the brake pedal.
2. Press and hold Neutral (N) for two seconds. This puts the vehicle into
car wash mode.
If the ENGINE START/STOP button is pressed while the vehicle is in car
wash mode, the power mode will change to ACCESSORY .
DRIVING
78 |
Auto Idle Stop
*1
To help maximize fuel economy, the engine automatically stops when the
vehicle comes to a stop, depending on environmental and vehicle operating
conditions.
n Activating Auto Idle Stop
When the vehicle stops with the gear
position in Drive (D) and the brake
pedal is pressed, the engine turns off
and the auto idle stop indicator
appears.
When you release the brake pedal, the
engine restarts and the vehicle begins
to move.
Auto idle stop may not activate (or the
engine may automatically restart) when the engine is warming up, the air
conditioning system is on, the 12V battery is charging, or when other
conditions are met. For a complete list of conditions, see your Owner's
Manual at owners.acura.com.
n Turning the System On or Off
*1 - If equipped
DRIVING
| 79
To Next Page
Loading...
