Acura MDX User Manual

uuLocking and Unlocking the DoorsuLocking/Unlocking the Doors from the Outside
148
Controls
To temporarily deactivate the function:
1. Set the power mode to OFF.
2. Open the driver’s door.
3. Using the master door lock switch, operate
the lock as follows:
Lock Unlock Lock Unlock.
u The beeper sounds and the function is
deactivated.
To restore the function:
• Set the power mode to ON.
• Lock the vehicle without using the auto lock
function.
• With the keyless access remote on you,
move out of the auto lock function
operation range.
• Open any door.
1Locking the doors and tailgate (Walk away auto lock)
You must wait until the power tailgate fully closes
before the auto lock function will be activated.
The auto lock function does not operate when any of
the following conditions are met.
• The keyless access remote is inside the vehicle.
• A door or the hood is not closed.
• The power mode is set to any mode other than
OFF.
• The keyless access remote is not located within a
radius of about 5 feet (1.5 m) from the vehicle
when you get out of the vehicle and close the
doors.
Auto lock function operation stop beeper
After the auto lock function has been activated, the
auto lock operation stop beeper sounds for
approximately two seconds in the following cases.
• The keyless access remote is put inside the vehicle
through a window.
• You are located too close to the vehicle.
• The keyless access remote is put inside the tailgate.
If the warning beeper sounds, check that you are
carrying the keyless access remote. Then, open/close
a door and confirm the auto lock activation beeper
sounds once.
18 ACURA MDX E-AWD-31TRX6100.book 148 ページ ２０１７年１１月１０日 金曜日 午前１０時２１分

Acura MDX Specifications

General

Brand	Acura
Model	MDX
Category	Automobile
Language	English