uuIf a Tire Goes FlatuTemporarily Repairing a Flat Tire
*
626
4. Plug in the compressor to the accessory
power socket.
u Be careful not to pinch the cord in a
door or window.
u Do not plug any other electric devices
into other accessory power sockets.
2 Accessory Power Sockets P. 216
5. Turn the power system on.
u Keep the power system on while
injecting sealant and air.
2 Carbon Monoxide Gas P. 80
6. Turn the selector knob to REPAIR.
1Injecting Sealant and Air
Do not operate the temporary tire repair kit compressor
for more than 15 minutes. The compressor can
overheat and become permanently damaged.
There are three accessory power sockets:
• In the console compartment
• In the front of the center pocket
• In the left side panel in the cargo area
2 Accessory Power Sockets P. 216
Until the sealant injection is complete, the pressure
shown on the pressure gauge will appear higher than
actual. After the sealant injection is complete the
pressure will drop and then begin to rise again as the
tire is inflated with air. This is normal. To accurately
measure the air pressure using the gauge, turn the air
compressor off only after the sealant injection is
complete.
Running the engine with the vehicle in an
enclosed or even partly enclosed area can
cause a rapid build-up of toxic carbon
monoxide.
Breathing this colorless, odorless gas can
cause unconsciousness and even death.
Only run the engine to power the air
compressor with the vehicle outdoors.
18 ACURA MDX E-AWD-31TRX6100.book 626 ページ ２０１７年１１月１０日 金曜日 午前１０時２１分
To Next Page
Loading...
Need help?
General
