1. Install the Fuses
To lower battery drain during vehicle shipping, the No. 14 BACK UP (7.5 A) and No. 29 AUDIO (10 A) fuses are
removed from the under-hood fuse/relay box and stored in the center console. Make sure you turn the ignition to OFF
and wait at least 1 minute before installing the fuses.
NOTES
After you install these fuses, the MIL will come on and stay on. To turn it off, follow these steps:
1.1. Make sure the parking brake is set and the transmission is in Park.
1.2. With your foot firmly on the brake pedal, press the ENGINE START/STOP button once. Wait for the READY
indicator in the instrument panel to come on.
1.3. Press and hold the ENGINE START/STOP button. Wait for the READY indicator to go off.
1.4. Repeat steps 1.2 and 1.3 five times or more. The MIL should go off.
2. Remove the Center Console and Door Panel Protective Coverings
The center console comes with a protective fabric covering. Carefully remove it without touching other interior parts.
The driver’s door comes with a protective covering that is tucked inside the edge of the door panel. To remove this
covering, flip it over the door and gently pull from the outside to avoid damage.
Page 5 of 25
To Next Page
Loading...
Need help?
General
