2 READ
Please read this entire manual carefully before you set up the instrument and begin to
use it. In this way you can become familiar with the features of the weather station
&
clock to get the most benefit from it.
3 INSTALL BATTERIES
Main Unit: Always install batteries into the main unit first. On the back of the unit,
remove the battery compartment cover. Insert 2 AA alkaline (or lithium - See NOTES
below) batteries. Replace the cover.
Wireless Sensor: After batteries have been put into the main unit, remove the back
cover of the wireless sensor. Insert 2 AAA alkaline (or lithium) batteries. Press the "TX"
button and replace the back cover on the sensor. Put the sensor aside for now, and
continue to learn about the main unit. Later, in part 5 of this manual you'll learn more
about the wireless sensor.
NOTE: When replacing the batteries for the remote sensor, remove the batteries from
the sensor and clear that sensor's channel on the main unit by pressing and holding the
CHANNEL button when the corresponding channel is displayed. Reinstall the batteries
into the wireless sensor and press and release the TX button to synchronize the units.
Operating Range of Batteries Severe cold (below -4° F/-20° C) can cause alkaline
batteries to freeze and function improperly. Use lithium
batteries in extremely low temperature conditions to
ensure continued operation.
Low Battery Indicator:
When the battery level is low for the main unit or the wireless sensor, the
low battery level icons will illuminate.
4 CHOOSE WHERE TO PLACE THE MAIN UNIT and WIRELESS SENSOR
Main Unit: Choose wall mount or table-top placement.
• Choose a location for each unit that is at least 10 feet away from other electronic
devices that may interfere with the wireless signal.
• Wall mounting: Use the mounting slot on the back of the unit to hang it from one of the
supplied screws.
• Table-top placement: Snap the base support to the main unit by inserting the support's
two barbed prongs into holes on the bottom edge of the main unit.
Wireless Sensor: When placing the sensor, consider these things:
• Although the sensor is designed for outdoor use, placement in a protected area will
prolong its life.
• Mounting: Use the mounting slot on the back of the unit to hang it from one of the
supplied screws.
• The sensor must be within 100 feet (30 meters) of the main unit.
• The sensor is resistant to weather and to water. It is NOT WATERPROOF.
• Prolonged exposure to cold weather may cause damage to the LCD panel.
• Wireless sensor must be placed outdoors to observe outdoor temperatures and
humidity.
2
Main Unit
BACK
Wireless Sensor
BACK
Placement
SET P+
P•
SNOOZE
= =
= =
= =
=
0 0 0 0
=
=
[
l
=
= =
=
[e
AA1.5v @p
=
= =
= =
=
QEE>
AA1.5v eJ
=
= =
= =
Snap-on Base
To access the battery
compartment and the
function buttons, open the
BACK (inside the case)
case along the bottom seam.
100 feet maximum
3
To Next Page
Loading...
