so you canimmediately start interacting, logging, and streaming the data your
projects produce without writing code.
If you've never used WipperSnapper, click below to read through the quick start guide
before continuing.
Quickstart: Adafruit IO
WipperSnapper
Wiring
First, wire up the soil sensor to your board exactly as follows. Here is an example of
the soil sensor wired to anAdafruit ESP32 Feather V2()using I2Cwith a STEMMA QT
cable (no soldering required)()
Board 3Vtosensor VIN (red wire on
STEMMA QT)
Board GNDtosensor GND (black wire on
STEMMA QT)
Board SCLtosensor SCL (yellow wire on
STEMMA QT)
Board SDAtosensor SDA (blue wire on
STEMMA QT)
Usage
Connect your board to Adafruit IO Wippersnapper and navigate to the
WipperSnapper board list().
©Adafruit Industries Page 12 of 19
To Next Page
Loading...
Need help?
General