Adafruit Industries STEMMA I2C - Page 16

TheSend Everyoption is specific to each sensor's measurements. This option will tell
the Feather how often it should read from the two sensors and send the data to
Adafruit IO. Measurements can range from every 30 seconds to every 24 hours.
For this example, set theSend Everyinterval for each sensor to "Every 30 seconds".
Your device interface should now show the sensor components you created. After the
interval you configured elapses, WipperSnapper will automatically read values from
the sensor(s) and send them to Adafruit IO.
©Adafruit Industries Page 16 of 19