EasyManua.ls Logo

Adam Flame Effect - Plug Replacement; Appliance Data

Adam Flame Effect
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Customer telephone helpline: 08448 809301
Helpline email address: helpline@adamsurrounds.co.uk
CO9039 V3_151110
- 11 -
PLUG REPLACEMENT
This appliance is supplied with a BS1363 3 pin plug fitted with a 13 Amp fuse.
Should the fuse require replacement, it must be replaced with a fuse rated at 13
Amp and approved to BS1362.
In the event the mains plug has to be removed/replaced for any reason, please
note:
The wires in the mains lead on this appliance are coloured in accordance with the
following code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
THIS APPLIANCE MUST BE EARTHED
As the colours may not correspond with the markings identifying the terminals in your
plug proceed as follows.
The green and yellow earth wire must be connected to the terminal in the plug
which is marked with the letter E or with the earth symbol
The blue wire must be connected to the terminal marked N
The brown wire must be connected to the terminal marked L
Important - any cut off plug should be disposed of safely to prevent hazard. There is
a danger of electric shock if a cut off plug is inserted into a socket outlet.
APPLIANCE DATA
Flame Effect Pebble Glow
Supply Voltage: AC 220-240V, 50Hz Supply Voltage: AC 220-240V, 50Hz
Rated Power: 2000W Rated Power: 2000W
Fuse Rating: 13 Amp Fuse Rating: 13 Amp
Lighting: 1 x 25W BC Bulb (MAX) Lighting: 1 x 40W BC Bulb (MAX)