Customer telephone helpline: 08448 809301
Helpline email address: helpline@adamsurrounds.co.uk
CO9039 V3_151110
- 6 -
INSTALLATION
This fire is inset and must be fixed to a surround (which must be fixed to a wall).
Please ensure the floor and wall is flat before installation.
NOTE: The fire and surround shown above are examples; this method applies
for all other inset fires.
to the back of the electric fire (as shown
right). Position the fire within the
surround and peel back the other side of
the Neoprene Strips.
Firmly push the electric fire against the
surround until it is secure, ensuring the
mains cable of the fire exits the same
side of the suite where the mains socket
is located.
Check the supply cable is not trapped
under the fire such that it may cause it to
be damaged.
To Next Page
Loading...