Customer telephone helpline: 08448 809301
Helpline email address: helpline@adamsurrounds.co.uk
CO9039 V3_151110
- 5 -
SAFETY CUT-OUT SYSTEM
PLEASE DO NOT OBSTRUCT THE AIR VENTS OF THE ELECTRIC FIRE.
This appliance has a ‘self resetting’ safety cut out system. To prevent overheating,
ensure the air inlets and outlets are not obstructed. If the safety cut-out operates,
switch off the electric fire and allow to fully cool down. Remove any obstruction
before re-use.
CAUTIONS
Do’s
• Always install the fire in accordance with this guide. If in doubt obtain expert
advice.
• Always make sure the electrical socket is accessible and located adjacent
to, but not above or behind the fire.
• Always disconnect the fire from the electrical supply before carrying out
cleaning, maintenance or replacing the light bulbs.
• Always make sure the fire is firmly secured.
Always ensure the product is assembled in an area that is free from du
grease or liquids.
• Always ensure that the correct tools are used to mount this fire.
• Always make sure the fire is firmly secured to the wall when complete
Don’ts
• Never leave children unsupervised in a room where the fire is ON and
unguarded.
• Never obstruct or cover the fan outlet or force items into fire openings.
• Never install or use the fire anywhere where water is in use, i.e. Bathrooms,
Kitchens, Shower Rooms, and Swimming Pool etc.
• Never use aerosols or steam cleaners on or around the fire.
• Never route the mains supply cable under carpet etc.
• Never install the fire close to curtains or combustible materials.
Never use the fire to dry clothes etc.
• Never sit or stand on the fire.
• Never lean or put weight on the fire.
• Do not use outdoors.
Do not position furniture, curtains or other combustible material closer than
1 metre from the heater.
• Do not site the fire on deep pile carpets or rugs.
• Never cut off the plug and hard wire into a fixed fused spur
To Next Page
Loading...
Need help?
General