Adam Flame Effect User Manual

Customer telephone helpline: 08448 809301
Helpline email address: helpline@adamsurrounds.co.uk
CO9039 V3_151110
- 2 -
CONTENTS
Fire Identification 1
Introduction 1
Handling 2
Unpacking 2
Parts Supplied 3
Electrical Specification 4
Maintenance 4
Safety Cut-Out System 5
Cautions 5
Installation 6
Fire Preparations (Pebble Glow Fires Only) 7
Operating the Fire 7
Changing the Bulb – Pebble Glow Fire 8
Changing the Bulb – Flame Effect Fire 9
Changing the Bulb – Traditional Fire 10
Plug Replacement 11
Appliance Data 11
Certifications 12
HANDLING
Before continuing any further with the installation of this fire please read the
following:
• When lifting always keep your back straight. Bend your legs and not your back.
• Avoid twisting at the waist. It is better to reposition your feet.
• Avoid upper body / top heavy bending. Always bend from the knees rather than
the waist. Do not lean forward or sideways whilst handling the fire.
• Always grip with the palm of the hand. Do not use the tips of fingers for support.
• Always keep the product as close to the body as possible. This will prevent
unnecessary and undue strain on the body.
• Use gloves to provide additional grip.
• Always use assistance if required.
UNPACKING THE PRODUCT
The unit is supplied in a single package carton. Carefully unpack the product using
the following procedure:
• Carefully lift the pieces out of the box
• Carefully remove the protective wrapping from the pieces
• Locate the fixing pack and put aside
• Carefully remove the electric fire from its box and put aside

Adam Flame Effect Specifications

General

Brand	Adam
Model	Flame Effect
Category	Indoor Fireplace
Language	English