Chapter 7: Installing the Driver and an Operating System ● 52
5 When all drivers have loaded, select No.
6 Complete the OpenServer installation, following the instructions included with your
operating system.
7 Continue with Managing Your Storage Space on page 59.
Installing with UnixWare
Note: You will need your UnixWare Installation CD to complete this task.
To install the driver when installing UnixWare:
1 Insert the UnixWare Installation CD.
2 Restart your computer.
3 Follow the on-screen instructions to begin the UnixWare installation.
4 When prompted to load more HBA drivers, insert the driver disk, then select Ye s . (To load
more HBA drivers, repeat this step.)
5 When all drivers have loaded, select No.
6 Complete the UnixWare installation, following the instructions included with your
operating system.
7 Continue with Managing Your Storage Space on page 59.
Installing with Solaris
Note: This task is not necessary if you are installing Solaris 10 Update 2 or later. Instead, you
can choose to install Solaris using the in-box driver and update it either during or after the
installation is complete, if required. You will need a floppy disk to complete this task.
To create a driver disk:
1 Start your computer.
2 Interrupt the autoboot, press the ESC key. The Device Configuration Assistant (DCA)
Utility will open.
3 Select F4_Add Driver.
4 Insert a floppy disk.
5 Complete the Solaris installation, following the instructions included with your operating
system.
To Next Page
Loading...
