Adaptec Command Line Utility - Arcconf Failover; Arcconf Getconfig

Chapter 2: Using the Command Line Utility ● 22
Syntax
ARCCONF DRIVERUPDATE <DirName>
Parameters
Driverupdate <DirName> is the directory path containing the driver that you want to update.
Example
ARCCONF DRIVERUPDATE C:\WINDOWSALL
arcconf failover
Turns automatic failover on and off.
Syntax
ARCCONF FAILOVER <Controller#> <on|off>
Parameters
Controller# is the controller number.
On turns the controller failover mode on.
Off turns the controller failover mode off.
Example
ARCCONF FAILOVER 1 ON
arcconf getconfig
Lists information about the controllers, logical drives, and physical devices. This information
can include (but is not limited to) the following items:
● Controller type
● BIOS, boot block, device driver, and firmware versions
● Logical drive status, RAID level and size,
● maxCache status (enabled/disabled), fetch and flush rate policy (low, medium, high), and
read/write balance
● Device type, device ID, presence of PFA, SSD status (SSD or not, part of maxCache pool,
maxCache pool compatibility)
● Physical device state
● Number of Solid State Disks (SSDs) assigned to maxCache pool, maximum number of
SSDs that can be assigned to maxCache pool
● Enclosure information: fan, power supply, and temperature status
Syntax
ARCCONF GETCONFIG <Controller#> [AD|LD [LD#]|PD|AL]
Parameters
Controller# is the controller number