Adaptec Command Line Utility - Arcconf Setstatsdatacollection; Arcconf Setvmcredential; Arcconf Task

Chapter 2: Using the Command Line Utility ● 36
arcconf setstatsdatacollection
Enables or disables statistics collection for a controller. To display the statistics, use the arcconf
getlogs command (see page 23).
Syntax
ARCCONF SETSTATSDATACOLLECTION <Controller#> Enable|Disable
Parameters
Controller# is the controller number.
Enable turns statistics collection on.
Disable turns statistics collection off.
Example
ARCCONF SETSTATSDATACOLLECTION 1 ENABLE
arcconf setvmcredential
Resets the Hypervisor login credentials for VMware Guest OSs running Remote ARCCONF.
Note:
This command is available for VMware Guest OSs running Remote ARCCONF only.
Syntax
SETVMCREDENTIAL <Esxip> <Esxcimomport> <Esxuserid> <Esxpassword> [noprompt]
Parameters
Esxip
is the Hypervisor IP address.
Esxcimomport
is the Hypervisor CiMOM port number.
Esxuserid
is the Hypervisor user name.
Esxpassword is the Hypervisor password.
Example
ARCCONF SETVMCREDENTIAL 172.18.46.101 5989 root passwd
arcconf task
Performs a task on a logical drive or a physical drive.
Syntax
ARCCONF TASK
TASK START <Controller#> LOGICALDRIVE <LogicalDrive#> <options> [noprompt]
TASK STOP <Controller#> LOGICALDRIVE <LogicalDrive#>
TASK START <Controller#> DEVICE <Channel> <ID> <options> [noprompt]
TASK STOP <Controller#> DEVICE <Channel> <ID>
Parameters
Controller# is the controller number
LogicalDrive# is the number of the logical drive in which the task is to be performed