INSTALLATION STEPS
1. REMOVE BLISTER PACK ALONG
WITH THE PRODUCT FROM THE
OUTER BOX.
2. INSERT FINGERS INTO THE
CUTOUTS, GRIP THE PRODUCT
FIRMLY, AND PULL FIRMLY. SLIDE
LEFT SIDE OF PRODUCT OUT OF THE
BLISTER PACK FIRST (TO PREVENT
DAMAGE TO THE POWER CABLE),
THEN REMOVE THE ENTIRE
PRODUCT.
3 INSERT THE PRODUCT INTO THE
M.2 SLOT ON THE MOTHERBOARD.
4. LOCATE THE SATA POWER
CABLE(SATA PIN) ON THE LEFT
SIDE OF THE PRODUCT.
To Next Page
Loading...
