© ADB bvba All Rights Reserved 7
2.2.7 Required Equipment Refer to Table 1 for required equipment that is supplied. Refer to Table 2 for required
equipment that is not supplied. Refer to the Parts section for part numbers.
Table 1: Required Equipment Supplied
Table 2: Required Equipment Not Supplied
Description Quantity
L-804 runway guard light. Includes lamps, frangible column, and 2-pin L-
823 cordset, or a 4-pin cordset, or a 5-pin cordset with matching harness.
1
Instruction manual 1 per order
Description Quantity
Level 1
L-867B light base plate (Part Number 1832RGL). This base plate must be
ordered as a separate item. Refer to the Warning below for using the L-
867B light base.
1
Wire, AWG 16 (minimum), 600 V−AWG 12 (maximum) 600 V As required
Ground wire, AWG 6, solid copper As required
Ground rods As required
Torque wrench As required
WARNING
Use only the L-867B heavy duty
light base supplied by ADB Airfield
Solutions.
Failure to observe this warning will
result in damage to the installed L-
804 RGL caused by high wind
loads.
See FAA specification AC
150/5345-46 wind loading
requirements.
To Next Page
Loading...
