MIKADO USER MANUAL
User Manual - page 32 www.adblighting.com
Issue 1.0
CHASERS If no crossfade or speed (rate) has been recorded in memory, rotate the
[crossfade] fader to adjust fade percentage between steps and/or the [speed]
fader to adjust the rate of speed in BPM "live".
To stop a running Chaser, start a stopped Chaser, manually step a Zero speed Chaser or re-
trigger a Chaser set to single shot effect, press and hold [start/stop/step], tap [F/A] (Chaser
number).
11.5 EDIT A MEMORY OR CHASER
Press and hold [MEMORY] until the "edit" LED lights. Press [PAGE](optional) [F/ A] (memory
to edit).
MEMORIES To edit a channel level, press and hold [F/A] (channel number) then use the
[FLASH/LEVEL] fader to set the level. To edit fade times, rotate the
[crossfade] rotary fader until the LED illuminates (this indicates that you have
matched the recorded crossfade level) then adjust using the time scale printed
around the rotary fader.
To exit, press and hold [MEMORY] until the "run" LED lights. Changes are
automatically saved.
CHASERS To control the SPEED, rotate the [speed] rotary fader until the LED starts
flashing. This indicates that you have matched the recorded speed, which
then can be adjusted using the flashing LED to gauge the speed. To change
the FADE between steps rotate the [crossfade] rotary fader until the LED
illuminates (this indicates that you have matched the recorded crossfade level)
then adjust using the time scale printed around the rotary fader. To change
the EFFECTS (direction, pattern or trigger), press and hold [function] then tap
[F/ A] (required effect).
To edit the levels in a step, press and hold [start/stop/step] (all steps light and
current step flashes), tap [F/ A] (step to edit). Press and hold [F/ A] (channel
number) then use the [FLASH/LEVEL] fader to set the level. Set other channel
levels as desired.
To delete a step, press and hold [start/stop/step] (all steps light and current
step flashes), tap [F/A] (step to delete). Press and hold [function], tap [F/A]
(delete).
To add a step, press and hold [start/stop/step] (all steps light and current step
flashes), tap [F/A] (the new step is inserted prior to the selected step). Press
and hold [function], tap [F/A] (add). Then either create the look on the output
then press [record memory]or to add an existing Memory, press [F/ A]
(Memory number).
To exit, press and hold [MEMORY] until the "run" LED lights. Changes are
automatically saved.
To Next Page
Loading...
Need help?
General
