113687-3 11
2 USE
2.1 Controls
2.2 Programs
NOTE: When the thermal stop is deactivated, the programmed wash time starts to run immediately without waiting
for the programmed water temperature to be reached.
2.3 Cycle Stop
The cycle stop is an important safety feature on all washers. It allows the washer to be stopped at any time, for any
reason.
When the cycle stop is pressed all motion stops immediately. The water will drain, and after 2 minutes the door will
unlock and the user will be prompted to open the door.
If the washer is in any of the self service modes (Central Pay, Card Reader, or Coin) there is a grace period at the start
of the wash cycle where the program can be restarted by the user after the cycle stop has been pressed.
a) The user can open the door to add or remove garments at this time.
b) The user can restart the same cycle, or choose a new cycle at this time. If the new cycle is more expensive than
the original program the user will be prompted to insert additional vend.
c) If there is no activity with 5 minutes of the open door prompt, the program will automatically end.
If the cycle stop is pressed after the grace period, the cycle will end, and the washer cannot be restarted without
initiating a new cycle and inserting another payment.
The grace period is variable between 0 and 9 minutes (default value is 1 minute), and is set in the configuration
menu. See that section of the manual for information on setting this parameter.
The cycle stop function cannot be turned off.
Program Remarks
P1
Cold Wash in cold water and two rinses
P2
Warm (104ºF) Wash at 104ºF and two rinses
P3
Hot (140ºF) Wash at 140ºF and two rinses
P4
Delicates Wash in cold water and delicates spin
P5
Extended cold Wash in cold water and three rinses
P6 Extended hot (140ºF) Wash at 140ºF and three rinses
P7
OPL (programmable) Default setting: Prewash, wash at 104ºF, three rinses and fast spin
Screen (2) The screen has 4 displays with 7 segments each and gives information regarding
the current operation.
START key Press Start to start a program, pause or continue the program after the pause. In
the menu navigation use the ENTER function to enter or go the next level in a
menu.
ADVANCE (>>) key
OPL
Press advance to accelerate a program. When this key is pressed the programmer
goes directly to run the next cycle of the program; where the cycle currently running
is the last, the program ends. Please note that if you press this key during a spin
cycle, the machine will not move to the next cycle until completion of the required
safety time to permit the drum to come to a complete standstill.
This option is not available in self-service mode.
INC (
∧
) and DEC (
∨
) keys The INC (
∧
) and DEC (
∨
) keys have different functions depending on the screen
and the programmer operating mode. Use these keys to select a wash program or
to scroll through different menus.
STOP key
Use this button to stop the washer for any reason. When the stop is pressed the
washer stops immediately regardless of mode or cycle. The water will drain and
after two minutes the door will unlock.
See the stop key section for a complete description of it’s function.
Cycle indicators (LEDS)
The user interface has 6 amber LEDs that indicate the status of the washer
extractor and the progress of the washing program in its different cycles. The
seventh LED is green and shows the door status: if it is lit then the door can be
opened, as the drum is no longer moving.
To Next Page
Loading...