450374 -1 www.adclaundry.com 3
Table of Contents _______________
List of Acronyms _____________________________
DSI Direct Spark Ignition
L.E.D. Light Emitting Diode
L.P. Liquid Propane
OSHA Occupational Safety and Health Administration
IMPORTANT
You must disconnect and lockout the
electric supply and the gas supply or the
steam supply before any covers or
guards are removed from the machine
to allow access for cleaning, adjusting,
installation, or testing of any equipment
per OSHA standards.
Please observe all safety precautions
displayed on the equipment and specified
in the installation and operator’s manual
included with the dryer.
FOR YOUR SAFETY
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
Do not dry mop heads in the dryer.
Do not use dryer in the presence of dry
cleaning fumes.
CAUTION
Dryers should never be left unattended
while in operation.
WARNING
Children should not be allowed to play
on or near the dryers.
Children should be supervised if near
dryer(s) in operation.
The dryer must never be operated with
any of the back guards, outer tops, or
service panels removed. Personal injury
or fire could result.
The dryer must never be operated
without the lint filter or screen in place,
even if an external lint collection system
is used.
The dryers must not be installed or stored
in an area where it will be exposed to
water or weather.
The wiring diagram for the dryer is
located in the front electrical control box
area.
Safety Precautions ...................................... 5
Routine Maintenance................................... 5
Cleaning ............................................................................ 5
Adjustments ...................................................................... 5
Lubrication ......................................................................... 5
Installation Requirements ........................... 6
Enclosure Air Supply
and Exhaust Requirements .............................................. 6
Electrical and Gas Requirements ..................................... 6
Operational Service Check Procedure ............................. 6
Description of Parts .................................... 7
Control Panel (Microprocessor) ........................................ 7
Main Door Switch and Front Panel ................................... 7
Lint Drawer ........................................................................ 7
Lint Box and Door and Switch
and Temperature Sensor Assembly ................................. 8
Tumbler ............................................................................. 8
Tumbler Bearing and Pulley Arrangement ....................... 8
Idler Bearing ...................................................................... 8
Drive Motor and Impellor .................................................. 9
Gas Burner ........................................................................ 9
Sail Switch ......................................................................... 9
Electrical Panel ................................................................. 9
Service ....................................................... 10
Controls (Computer) ....................................................... 10
Thermostats and Temperature Sensor ........................... 13
Sail Switch Assembly ...................................................... 13
Front Panel and Main Door Assemblies ......................... 14
Tumbler and Bearing Assembly ...................................... 15
Idler and Bearing Assembly ............................................ 15
Drive Pulley ..................................................................... 16
Tumbler ........................................................................... 16
V-Belts ............................................................................. 17
Motor ............................................................................... 17
Impellor............................................................................ 17
Lint Screen ...................................................................... 18