ADC Advantage 2200 - Battery Installation; Strap Installation

5
Strap Installation (figure 2)
1. Thread thinner end of the strap through the loop.
2. Thread thicker end of the strap through the threaded end before pulling it tightly.
Note:
• Battery polarity should be observed to prevent damage to the device.
• When battery is low, the battery indicator symbol on the display will flash. Replace low battery
as soon as possible. Remove battery if the device will not be used for more than 30 days.
SpO
2
%
PR BPM
99
56
SpO
2
%
PR BPM
99
56
1.
2.
(Figure 2)
Battery Installation (figure 1)
1. Slide off battery cover in direction of arrow.
2. Put the two AAA batteries into battery compartment by observing correct polarity.
3. Slide the battery cover on by reversing Step #1.
1
Sp
0
2
P
u
lse Oxime
t
e
r
Power
2
x
1.5V AAA
SN:
Model: 2200
(Figure 1)