93-9005-00 ADView 2 User Manual | 22
September 1, 2016
Turn the Selection Knob in either direction to select the desired icon
After making your selection, wait 2 seconds. The selected icon will be the one flashing.
Once you have selected the intended mode, press the Selection Knob to finalize this selection.
Note: Adult and Pediatric mode can be used in conjunction with any type of measurement mode.
Step 3: Select Measurement Mode
The ADView 2 offers three different ways to measure BP.
Single Measurement Mode: You can take a single, automatic measurement.
Averaging Measurement Mode: Automatically take and average up to 5 multiple BP measurements.
Manual Mode. Allows you to verify an automated oscillometric BP reading with a manual auscultatory measurement.
Note: Use of Manual Mode may be required to meet certain clinical trial protocols. It also can be used to verify a BP
reading if the automated BP results diverge significantly from a patient’s prior history, or if you as the clinician deem
it necessary. Manual Mode mimics a traditional sphygmomanometer and does not measure Systolic or Diastolic
blood pressure.
Note: Averaging Measurement Mode can only be used for Automatic BP Measurements. It cannot be used to
automatically average measurements taken in Manual Mode.
!
Single Measurement Mode
This is the device’s default mode. The ADView 2 will be in this mode each time it is powered up.
Pressing the Home button will also revert to single measurement mode.
!
Example of center display when Single Measurement Mode is selected
Note: If you see the Auscultatory SphygMode Icon or the Averaging Mode Icon , press the Mode Toggle Button
in succession until these icons no longer show to return to Single Measurement Mode.
To Next Page
Loading...