30 113688-1
Copy program?
Next, select the source program. With the INC (
∧∧
∧∧
∧) and
DEC (
∨∨
∨∨
∨) keys, the source program number is selected
and the corresponding name displayed. Once the
program number has been selected, press ENTER.
ENTER: Accept / ESC: Cancel / <<: Previous menu
4.6.3 Change program
This command allows for inserting, modifying or erasing
a block in a program, The steps to follow are the
following:
After selecting CHANGE PROGRAM, press the ENTER
key and the number of the first available program will
be displayed with its name:
CHANGE PROGRAM
Programme: 21
BLANKETS
With the INC (
∧∧
∧∧
∧) and DEC (
∨∨
∨∨
∨) keys, the program number
is selected. Press ENTER.
CHANGE PROGRAMME
Programme: 21
Program name
BLANKETS
Use the INC (
∧∧
∧∧
∧) and DEC (
∨∨
∨∨
∨) keys to select the name.
Next if we press ENTER, the new name is selected.
Program 18
BLANKETS
Cycle: 1
Pre-wash
With the INC (
∧∧
∧∧
∧) and DEC (
∨∨
∨∨
∨) keys, the cycle number
is selected. Press ENTER.
MODIFY
INSERT
ELIMINATE
4.6.4 Insert
This command allows for a cycle to be inserted in a
program. The steps to follow are the following:
After selecting INSERT, press ENTER and the first cycle
will be displayed with its name.
BLANKETS
Cycle: 1
Pre-wash
Block:
With the INC (
∧∧
∧∧
∧) and DEC (
∨∨
∨∨
∨) keys, the cycle name can
be chosen amongst those saved in the memory. Once
this name has been selected, press ENTER and the
first available block will be displayed:
Use the INC (
∧∧
∧∧
∧) and DEC (
∨∨
∨∨
∨) keys to select the block
and then press ENTER.
ENTER: Accept / ESC: Cancel / <<: Previous menu
4.6.5 Modify
This command allows for a program cycle to be
modified. The steps to follow are the following:
After selecting MODIFY, press ENTER and the first cycle
will be displayed with its name.
With the INC (
∧∧
∧∧
∧) and DEC (
∨∨
∨∨
∨) keys, the cycle name can
be chosen amongst those saved in the memory. Once
this name has been selected, press ENTER and the
first available block will be displayed:
Cycle 1
Washing
Block: 7
Prewash 90°C
Insert cycle?
Cycle: 1
Washing
Block: 7
Prewash 90°C
Cycle: 1
Washing
Block: 7
Prewash 90°C
Use the INC (
∧∧
∧∧
∧) and DEC (
∨∨
∨∨
∨) keys to select the block
and then press ENTER. Press the INFO key to view the
parameters of this block.
Change cycle?
Remove cycle?
ENTER: Accept / ESC: Cancel / <<: Previous menu
4.6.6 Erase
This command allows a program cycle to be erased.
The steps to follow are the following:
After selecting the cycle to be eliminated press ENTER
and select ERASE.
To Next Page
Loading...
