Installation Code and Annual Inspections:
All installations and service of ADDISON equipment must be performed by a contractor qualified in the installation and
service of equipment sold and supplied by Addison and conform to all requirements set forth in the ADDISON manuals
and all applicable governmental authorities pertaining to the installation, service and operation of the equipment. To help
facilitate optimum performance and safety, Addison recommends that a qualified contractor annually inspect your
ADDISON equipment and perform service where necessary, using only replacement parts sold and supplied by
ADDISON.
Further Information: Applications, engineering and detailed guidance on systems design, installation and equipment
performance is available through ADDISON representatives. Please contact us for any further information you may
require, including the Installation, Operation and Service Manual.
These products are not for residential use.
This document is intended to assist licensed professionals in the exercise of their professional judgment
.
7050 Overland Road
Orlando, FL 32810 USA
Telephone: 407.292.4400
Fax: 407.290.1329
www.addison-hvac.com
© 2008 Addison All rights reserved. No part of this work covered by the copyrights herein may be reproduced or copied
in any form or by any means - graphic, electronic, or mechanical, including photocopying, recording,
taping or information storage and retrieval systems - without the written permission of Addison.
Printed in the USA #527I-0BJS 0308
To Previous Page
Loading...
