60
WS 1911 weather station
Start-up
Proceed in the order listed below and rst
insert the batteries into the outdoor sensor.
Only then can the weather station function
without aws.
Do not use rechargeable batteries, since
their voltage is too low (only 1.2 V instead of
1.5 V). This aects, among other things, the
precision of the measurements.
Where possible, use alkaline rather than
zinc-carbon batteries. Alkaline batteries
last longer, especially at low outdoor
temperatures.
Wireless outdoor sensor
1. Remove the battery compartment cover on the rear
side of the outdoor sensor by pressing with a little force
on the imprinted arrow. Slide the battery compartment
cover in the direction of the arrow, away from the
outdoor sensor.
2. Insert 2 batteries of type LR3/R3 (AAA)/1.5 V as depicted
on the bottom of the battery compartment. Pay
attention to the correct polarity of the batteries (+/-).
3. Slide the battery compartment cover back into place
on the outdoor sensor.
To Next Page
Loading...
