J
OUTLINE OF INSTALLED UNIT
-------- ______ ------
-em----__------
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
TOP
l 7-3/v
f
THIS CUT-OUT FOR FLUSH MOUNTING ONLY./
BEFORE CUTTING. REFER TO “FLUSH WALL
MOUNTING” IN THE INSTALLATION MANUAL
FOR COMPLETE INSTRUCTIONS.
A
4-13/l 6”
1
*
\
SURFACE MOUNTING
HOLES (A, B) AND CUT-OUT (C) \
I L
I
I
!
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I . .
I
I
L------------------_--____--------
INSTRUCTIONS FOR SURFACE MOUNTING TO “SURFACE MOUNTING” AT LEFT FOR COMPLETE
1. USE THIS TEMPLATE TO MARK LOCATIONS OF HOLES TO BE
INSTRUCTIONS.
DRILLED IN MOUNTING SURFACE. HOLES A ARE FOR P.SCREWS INSTALLED IN LOCATIONS A SHOULD HAVE THEIR
KEYSLOT MOUNTING; B ARE FOR OPIIONAL USE FOR EXTRA HEADS PROTRUDING APPROXIMATELY l/16” FROM THE
SECURITY OR FOR USE WITH THE ZONE LOCATOR CARD
(SEE OPPOSITE SIDE OF THIS TEMPLATE); CUT-OUT C IS
MOUNTING SURFACE (l/8” WITH THE ZONE LOCATOR CARD
REQUIRED FOR WIRING ACCESS. BEFORE CUlTlNG, REFER
DESCRIBED ON THE OTHER SIDE).
SURFACE/FLUSH MOUNTING TEMPLATE FOR CONSOLES
N421 iV4 1 Of93
www.PDF-Zoo.com
To Next Page
Loading...
