What to do if ADEMCO Keypad 6128RF Receiver is not communicating?
If your ADEMCO Keypad 6128RF Receiver isn't communicating, first ensure the Data In (DI) wire is properly connected. If other devices on the keypad terminals aren't communicating with the control panel, check the wiring between the control and all other devices.
How to fix open circuit on ADEMCO 6128RF?
If you are experiencing an open circuit with your ADEMCO Keypad, check that the Data Out (DO) wire is properly connected.
What to do if ADEMCO 6128RF wireless key has low battery?
If the wireless key for your ADEMCO Keypad has a replaceable battery, replace it. If the wireless key does not have a replaceable battery, replace the transmitter.
General| Type | Wireless Keypad |
|---|---|
| Power Source | Battery |
| Wireless Frequency | 345 MHz |
| Range | Up to 200 feet |
| Display | LCD |
| Compatibility | ADEMCO/Honeywell wireless alarm systems |
| Zones | Supports 8 wireless zones |
Describes the 2-digit display, READY LED, and ARMED LED on the keypad.
Explains how to activate panic alarms using specific key combinations.
Details function keys behind a decorative door and the Piezo-electric sounder.
Notes the space for a zone ID label and support for encrypted wireless keys.
Instructions on how to access the User Mode by pressing keys [1] and [3] simultaneously after powering the unit.
Procedure to enable or disable wireless keys (1-8) by entering their number and desired status.
How to exit the User Mode by pressing the [*] key when the display shows 'dE' and a '-' flashing.
