What does it mean if the transmitter zone number appears during Transmitter Sniffer mode on my ADEMCO LYNXR, but does not clear?
- GGerald AdamsSep 12, 2025
If a transmitter zone number appears during the Transmitter Sniffer mode but doesn't clear on your ADEMCO Security System, it could be due to a few reasons. The transmitter zone type (ZT) might be set to 00 (Not Used); set ZT to a valid active zone type in field *56. Another possibility is that the transmitter battery is not installed; install the proper battery. Lastly, a 5800 System transmitter might not be 'entered' in the system; "Enter" the unit in field *56 or *83.